ISE Sonos - Setting General Parameters; Parameter Page Common

ise smart connect KNX Sonos
Configuration
Order No. 1-0001-002
Product Manual Page 27 (76)
6.4 Setting general parameters.
Parameter page Common
The default value of each parameter is marked in bold.
Parameter
Entry/Selection
Remarks
Master-Slave group
configuration
Auto-discover
(only one master
without slaves)
Any available Sonos device from the local network is
selected automatically and used as a master of the
first group. Do not use this mode if multiple Sonos
devices are available on the local network. The se-
lection can change at any time if another Sonos de-
vice is detected.
1 group
2 groups
3 groups
4 groups
5 groups
Determines the number of groups for which commu-
nication objects are to be available. One master and
up to five slaves can be entered for each group.
Dynamic group support
(master/slave)
Yes
No
Select Yes to make the communication objects avail-
able for group volume and to activate the parameters
for slave IP addresses.
Select No if you only want to configure the masters
and do not need slaves or communication objects for
the group volume.
Speed text display
Slow
Normal
Fast
Controls the cycle rate at which group telegrams are
sent for artist/track/album texts to create a ticker ef-
fect.
Pay attention to the bus load here (cyclical telegrams
with maximum data width). KNX TP can transmit up
to 25 telegrams of this type per second. If in doubt,
choose the Slow setting or deactivate cyclical trans-
mission by selecting shortened display in the Text
wrap parameter.
Text wrapping
Ticker
Artist/track/album texts which are longer than 14
characters are displayed as repeating sequences of
14-character telegrams. The text is run through from
beginning to end. Each telegram begins one charac-
ter further back in the text as the previous one.
The speed of the ticker text can be set with Text dis-
play speed.