ISE Sonos - Master-Slave Group Parameter Tab

ise smart connect KNX Sonos
Configuration
Order No. 1-0001-002
Product Manual Page 29 (76)
Master-Slave Group parameter tab
There is a parameter page for the IP addresses of the master and slave devices for each active group.
Parameter
Entry/Selection
Remarks
Group #N - Master
The IP address of
a Sonos device
E.g.
192.178.168.20
This device can be controlled as the master. Only IPv4
addresses can be used.
When you enter a fixed IP address for the Sonos mas-
ter (in contrast to Auto-Discover), the full functionality
of the ise smart connect KNX Sonos, including multi-
master operation and dynamic group assignment, is
available.
(See also Section 6.4.3 − Determining the IP address-
es of the Sonos devices on the data network.)
0.0.0.0
Special case in group 1: Results in Automatic detec-
tion (comp. 6.4.1 Parameter page ); otherwise, the
master is not available.
Group #N – Number of
slaves
None
1 slave
2 slaves
3 slaves
4 slaves
5 slaves
Only available if Support for dynamic group creation
(comp. 6.4.1 Parameter page ) is activated.
Determines the number of slave addresses which can
be set. A set of group objects is activated for each
slave.
Group #N – Slave #M
The IP address of
a Sonos device
The local IP address can be entered for each slave
here.
(See also Section 6.4.3 − Determining the IP address-
es of the Sonos devices on the data network.)
0.0.0.0
Special case: Slave not available.