audio devices via KNX.
Control with the usual KNX operating devices, regardless of the SonosApp.
Control up to 30 Sonos devices via KNX.
Dynamic group creation via KNX objects for maximum multi-room
audio fun in up to five groups.
Using the "party mode" function, a Sonos device (master) can specify
the sound for all the devices in the house.
Supports five master-slave groups, each with one master and up to
five slave devices per group.
Volume control for masters, slaves and the entire group.
Controller for playing playlists.
Play music from the microSD card in the device.
Current title, artist and album on the KNX text objects.
Changes made using the SonosApp or PC are reported on the KNX
TP bus (playlist selection, volume, mute/unmute etc.).
An integrated data network switch (two RJ45 connections) simplifies the connection of multiple IP
devices. This enables multiple ise smart connect KNX Sonoss or other IP devices in the distribution
to be connected without the aid of other active components.
Supports accelerated transmission from the ETS to the ise smart connect KNX Sonos via a direct
IP connection.
The ise smart connect KNX Sonos is configured using the ETS, version 4.2 resp. 5.0.2 and up. The
application access ETS functions not supported by earlier ETS versions. This is why previous ver-
sions of ETS cannot be used for configuration.
Sonos is a registered trademark of Sonos, Inc. in the USA, Canada, Great Britain, Belgium, Luxembourg, the Netherlands, Japan, Mexico,
Germany, Russia and Australia and is a trademark of Sonos, Inc. in other countries.
To Next Page
Loading...
