Digital Network Public Address & Voice Alarm System
Step 3: Click the [Line 2] button in audio source control bar on the right, then you can operate the
selected audio source in selected partition.
Step 4: Play audio source in specified partition, then the color of audio LED will change accordingly.
Meanwhile, in the partition information table box, partition status LED light will change accordingly.
Notice: Partition selection includes two modes, [Normal View mode] and [check View mode], you can
freely switch the mode in the context menu of "Information area".
1. On the partition list, right click the menu to switch modes.
2: In normal view mode, you could select several partitions like below picture. The parts in highlight color
(partition4, 5, 6) are selected partitions.
3: Check box Mode: click to select the partition. Below 4, 5, 6 partitions are selected, and partitions1, 2, 3
are not selected:
To Next Page
Loading...