ITW Alpine ALS 4.0 XE - 3.2.2 Current Stock Length Menu; 3.2.3 Utility Tools

13
ALS 4.0 XE
PRODUCT MANUAL
EN
Figure 9
3.2.2 Current Stock Length Menu
This screen is only available if running
single stock option and without Auto-
Infeed. This screen allows you to select the
stock length the user want to use. Touch
the white area inside the box to bring the
screen up. Select the desired length of
stock by checking the small box next to
the length.
NOTE
There is no EXIT button for this screen.
Selecting any board length from lumber list
will exit this screen.
3.2.3 Utility Tools
Click on the utility tool icon and the following menu screen will
appear:
Figure 10
1. MARK PIECE CUT – Will mark the piece you
have selected as completely cut. The piece
will turn red. Be sure you have selected the
piece you want to mark before touching this
button.
2. RESTORE PIECE – Removes any stored cut
information for the selected piece restoring it
to uncut status.
3. MARK JOB CUT – Will mark the job you have
selected as completely cut. Be sure you have
selected the job you want to mark before
touching this button.
4. RESTORE JOB – Removes cut information for
the selected job restoring it to uncut status.
5. RESTORE PARTIAL PIECES – Restores Partial
pieces.
6. CHANGE PIECE QUANTITY – Allows you to
change the quantity of the selected piece.
When you touch this button, another screen
will pop up. If the selected piece is used in
more than one location, you will need to
choose the one you want to change. When
that is done, a screen will appear that will
allow you to set the quantity for that piece to
whatever you need.
7. ADD TO STANDARD PIECES – Will
automatically add the selected piece to
the list of Standard Pieces. See 4.4.1.6 for a
discussion of Standard Pieces.
8. DELETE PIECE – Deletes the selected piece
9. MERGE JOB – Merges two or more jobs in to
one job.
10. CHANGE LENGTH – Allows user to change
the selected piece length.
11. CANCEL – Will cancel out of this screen and
leave all cut data intact.