ITW Alpine ALS 4.0 XE - 3.12 XML Files; 1. GENERAL; 2. SYSTEM; 3. AXIS PARAMETER L1-L2-L1 P

37
ALS 4.0 XE
PRODUCT MANUAL
EN
4. AXIS PARAMETER A1-B1-T1 – This tab has speed,
accel, decel, software limits and other mechanical
settings for A1,B1 AND T1 Axes.
Figure 59
5. AXIS PARAMETER Z1 – This tab has speed, accel,
decel, software limits and other mechanical settings
for Z1 Axis.
Figure 60
6. EXPORT CHANGES – pressing this button or icon
will write the parameter changes to the controller.
7. SAVE CHANGES – Pressing this icon will save all
changes made to the system settings
!
CAUTION
Do NOT change these parameters without specific instructions
from an Alpine Equipment Customer Service.
AlpineLE.xml is a le that contains motion control
parameters; these should only be changed by Alpine
Equipment Customer Service.
!
WARNING
Changes to settings in this file can damage the machine and will
void the warranty.
3.12 XML Files
AlpineLE.xml is a le that contains parameters that
aect the operation of the ALS 4.0 XE. The settings can
only be changed or modied by Alpine Equipment
Customer Service. The access to these settings are
locked shown only for educational purposes.
Figure 56
The following describes the function of each button:
1. GENERAL – This tab has settings related to small
part ejection .
2. SYSTEM – This tab has various system settings to
control speed, osets and time delays.
Figure 57
3. AXIS PARAMETER L1-L2-L1P – This tab has speed,
accel, decel, software limits and other mechanical
settings for L1,L2 AND L1P Axes.
Figure 58