ITW Alpine ALS 4.0 XE User Manual

71
ALS 4.0 XE
PRODUCT MANUAL
EN
CONDITION CAUSE CHECK CORRECTION
6.16 E-Stop Troubleshooting
Cannot recover from E-Stop
condition
Check all E-Stop buttons on the
ALS (Figure 1) to determine if any
are pressed.
Check that three LED lights are
illuminated on the safety relay
module.
Return all E-Stop switches to
operating condition, pulling then
out and then press the blade reset
button.
If the relays are not illuminated
contact Alpine Equipment
Customer Service for further
assistance.
Thermistor overheating
(see warnings below)
Read WARNINGS and NOTE
below.
Call Alpine Equipment Customer
Service for further assistance
with this issue. Additionally,
see the warning notes below
regarding this issue.

ITW Alpine ALS 4.0 XE Specifications

General

Brand	ITW
Model	Alpine ALS 4.0 XE
Category	Saw
Language	English