ITW Alpine ALS 4.0 XE User Manual

2
ALS 4.0 XE
PRODUCT MANUAL
EN
!
WARNING
Read the following warnings before using this equipment.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT.
ADDITIONAL COPIES ARE AVAILABLE, CALL ALPINE EQUIPMENT CUSTOMER SERVICE: 8005219790.
READ THE MANUAL
Before operating equipment,
read and understand all safety,
operation and maintenance
information provided in the
operation manual.
HOT SURFACE HAZARD
Contact may cause burns. Allow to
cool before servicing.
WEAR SAFETY GLASSES
Failure to wear safety glasses with
side shields could result in serious
eye injury or blindness.
KEEP EQUIPMENT GUARDS
IN PLACE
Do not operate the equipment
if the safety devices have been
removed.
OPERATOR TRAINING
All personnel must be trained
before operating equipment.
KNOW WHERE AND HOW TO
SHUT OFF THE EQUIPMENT IN
CASE OF AN EMERGENCY
DEENERGIZE, DEPRESSURIZE,
DISCONNECT AND LOCK OUT
ALL POWER SOURCES DURING
MAINTENANCE
Failure to de-energize, disconnect
and lock out all power supplies
before performing equipment
maintenance could cause serious
injury or death.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause
the equip ment to rupture,
malfunction, or start unexpectedly
and result in serious injury.
Read the following safety information
before using this equipment:
In this installation guide, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows:
!
CAUTION
Hazards or unsafe practices that could
result in minor personal injury, product or
property damage.
!
WARNING
Hazards or unsafe practices that could
result in severe personal injury, death or
substantial property damage.
NOTE
Important installation, operation or
maintenance information.
For more information, see Alpine Manual M1002—“Equipment Safety Precautions”. Additional copies of the safety procedures can be ordered by calling 800-521-9790.
INSPECT EQUIPMENT DAILY
Broken or worn machine parts can
cause damage to equipment.
NEVER MODIFY EQUIPMENT
Modification could damage
equipment or cause it to operate
improperly. Modified equipment
could cause a safety risk to
operators.
PINCH POINTS
Moving equipment, sliding doors
and clamping devices can cause
pinch points for operators and
maintenance staff.
AUTOMATED EQUIPMENT
With automatic equipment,
the hazard of an unannounced
startup is present.
CUTTING EQUIPMENT
Cutting hazards are present with
Alpine Linear and Component
Saws. Be aware of sharp
equipment edges and spinning
blades.
ASSEMBLY EQUIPMENT
Crush hazard is present with
Alpine assembly systems. Failure
to inspect safety systems could
increase the probability of a crush
hazard occurring.
ELECTRICAL EQUIPMENT
High voltage equipment is
utilized. Arcing in areas of
flammable or combustible
materials may occur. Personnel are
exposed to high voltage during
operation and maintenance.
Protection against inadvertent arcing that may cause
a fire or explosion is lost if safety circuits are disabled
during operation. Loose electrical connections
could cause damage to components on your Alpine
Equipment. Electrical shock can occur while working
in the electrical cabinet.
CLOTHING AND JEWELRY
Loose clothing could be caught
on moving machine parts.
Jewelry, including rings, should
never be worn when operating
equipment.

ITW Alpine ALS 4.0 XE Specifications

General

Brand	ITW
Model	Alpine ALS 4.0 XE
Category	Saw
Language	English