ITW Alpine ALS 4.0 XE - 6. Troubleshooting; 6.1 Incorrect Homing;Cannot Home the Machine; 6.2 Centerline is Off; 6.3 Length is not Correct

4
ALS 4.0 XE
PRODUCT MANUAL
EN
Contents (continued)
6. Troubleshooting ...................................65
6.1 Incorrect Homing/Cannot Home the Machine ...........65
6.2 Centerline is O ........................................65
6.3 Length is not Correct ...................................65
6.4 Conveyor will not Start ..................................66
6.5 Printer will not Print. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 66
6.6 Prints Same Information ................................67
6.7 Cannot Read the Print Information ......................67
6.8 Inconsistent Print Placement ............................67
6.9 Automated Infeed Bad Lumber Load ....................68
6.10 Automated Infeed will not Start .........................68
6.11 L1 Belt Runs in Reverse. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68
6.12 Pneumatic Cylinder does not Actuate or Actuates Slowly . 69
6.13 Blade Motor will not Start ...............................69
6.14 Machine Stops during Cutting Operation ................69
6.15 Bevel Troubleshooting ..................................70
6.16 E-Stop Troubleshooting ................................. 71
7 Error Log Diagnostics ..............................72
7.1 System Diagnostics and Troubleshooting ................ 72
Appendix A – Maintenance Intervals ...................73
Appendix B – Pneumatic System Schematic ............74
Appendix B – Pneumatic System Schematic – ..........75
L1/L2 Blow-o
Appendix C – Unit Conversion Tables ..................76
Appendix D – Terms Glossary ..........................78
Appendix E – Warranty ................................79
Appendix F – Bibliography ............................79