ITW Alpine ALS 4.0 XE - Page 44

44
ALS 4.0 XE
PRODUCT MANUAL
EN
Step 15 – Release the L1 & L2 Clamps using the “L1
Clamp Up” and “L2 Clamp Up” buttons on the Manual
Control Screen.
Figure 106
Step 16 – Release the L1 & L2 Pushers using the “L1
Pusher Out” and “L2 Pusher Out” buttons on the Manual
Control Screen.
Figure 107
Step 17 – Remove the board from the saw and measure
the distance from the back fence side of the lumber
to the middle of the Centerline cut using a framing
square. This dimension should be 1.75” (45mm). If so, it
is calibrated – go to the next section.
Direction of Feed
1.75” (45mm)
Figure 108
Step 18 – If the Centerline is o, the hard stop on the
back of the T plate will need to be adjusted.
Step 19 – Turn o the blade motor and the conveyor.
Once the saw stops, open the door to the saw cabinet,
and then shut down the computer
Step 20 – Disconnect the electricity and air supply.
Step 21 – Lock and tag out the electrical and air supply
in accordance with OSHA procedures (i.e. OSHA 29 CFR
1910.147).
Step 9 – Jog Z1 down using
the “Jog Z1 Down” button the
Manual Control Screen until it
cuts about 3/8” into the board.
Step 10 – Move Z1 back to “0.0”
using the “Move Z1” button on
the Manual Control Screen.
Step 11 – Move A1 to 135° using
the “Move A1” button on the
Manual Control Screen.
Step 12 – Jog Z1 down using
the “Jog Z1 Down” button the
Manual Control Screen until it
cuts about 3/8” into the board.
Step 13 – Move Z1 back to “0.0”
using the “Move Z1” button on
the Manual Control Screen.
Step 14 – Stop the blade using
the “Saw Motor O” button on
the Manual Control Screen.
Figure 100
Figure 101
Figure 102
Figure 103
Figure 104
Figure 105