ITW Alpine ALS 4.0 XE - Page 48

48
ALS 4.0 XE
PRODUCT MANUAL
EN
Step 12 – Stop the blade using the “Saw Motor O”
button on the Manual Control Screen.
Figure 129
Step 13 – Release the L1 & L2 Clamps using the “L1
Clamp Up” and “L2 Clamp Up” buttons on the Manual
Control Screen.
Figure 130
Step 14 – Release the L1 & L2 Pushers using the “L1
Pusher Out” and “L2 Pusher Out” buttons on the Manual
Control Screen.
Figure 131
Step 15 – Using a framing square on the surface of the
board that was against the fence, check the groove as
shown.
Figure 132
If the cut is square, the calibration procedure has been
successfully completed.
!
WARNING
If the cut is not square, contact Alpine Equipment Customer
Service for proper procedures, failure to follow proper procedures
may result in damage to machine.
Step 9 – Manually Jog T1 forward until a groove has
been cut across the full width of the lumber using the
“Jog T1 Fwd” button on the Manual Control Screen.
Figure 125
Figure 126
Step 10 – Move Z1 back to “0.0” using the “Z1 Move”
button on the Manual Control Screen.
Figure 127
Step 11 – Move A1 to 90° using the “A1 Move” button on
the Manual Control Screen.
Figure 128