Operation
Starting the Engine
109 109
9811/9950-1
2 Start the engine as shown in Starting the Engine.
When the engine starts, the red LED B comes ON for
three seconds then goes OFF.
Note: The position of the red LED B can change
depending on the machine type.
T023301-1
Fig 52.
To Arm the Immobiliser
1 Stop the engine and remove the starter key.
The immobiliser arms automatically immediately. The
red LED B flashes for 60 seconds then goes OFF.
To Add a New or Additional Starter key
Note: Starter keys can be programmed to start more than
one machine.
1 Put the master key in the starter switch then turn the
starter switch to position I. The LED will flash 3 times.
2 Turn the starter switch to position 0 then remove the
master key.
3 Put a new or an additional starter key in the starter
switch then turn the starter switch to position I. The
LED will flash 4 times to confirm the starter key has
been added.
B
To Next Page
Loading...
Need help?
General
