Section 3 - Maintenance
Routine Maintenance
Engine Oil and Filter
3-18 3-18
9803/9390-2
Fig 8.
2 Change the Filter.
a Unscrew the filter 9-2.
b Clean the filter head especially on its sealing face.
Fig 9.
Note: The old seal can stick to the filter head. Ensure that
it is removed.
c Smear the rubber seal on the new filter with oil.
Screw in the new filter, hand-tight only.
3 Fill the System.
Fill the engine to the upper mark on the dipstick with
new oil through the filler (K
Checking the Oil
Level ( T 3-17)). For recommended oil grades
K
Lubricants and Capacities ( T 3-8). Wipe off any
spilt oil. Check for leaks. Make sure the filler cap is
correctly refitted.
4 Check for Leaks.
Run the engine for a few minutes to allow the oil to
circulate.
5 Stop the engine and check for leaks. Recheck the oil
level and top up if required.
1
To Next Page
Loading...