Note: For European installations (EN50131 certified), you can not arm the system without a valid
user code. If you do not have a valid user code, do not attempt to initiate the arm sequence for
the alarm system.
After you initiate the arming sequence, the system completes the following actions:
• The Armed indicator turns on.
• The Ready indicator remains lit.
• The Exit Delay time begins to count down.
• The keypad beeps six times, and continues to beep once each second. In the final 10 seconds,
the system beeps rapidly.
Note: For European installations (EN50131 certified), the Armed indicator turns on only after the
Exit Delay.
When the Exit Delay timer expires, the system is Armed and the following actions occur:
• The Ready indicator turns off.
• The Armed indicator remains on.
• The keypad stops sounding.
Note: The installer configures the Exit Delay timer in accordance with the North American and
European certification requirements (UL, ULC, and EN50131).
Canceling the arming sequence
To cancel the arming sequence, complete the following step:
• Enter your access code, or present a proximity tag to the keypad reader.
Arming the system in Stay mode
Stay mode partially activates the alarm system by arming all perimeter sensors, and bypassing all
interior sensors.
Note: For European installations (EN50131 certified), the Keypad Blanking feature activates after
30 seconds. You can see the status of the alarm system only after you enter a valid user code.
To arm the system in Stay mode, complete the following steps:
1. Ensure that you close all windows and doors.
2. Ensure that the Ready indicator is on.
3. Press and hold the Stay key for 2 seconds. If it is necessary, enter an access code, or present a
proximity tag to the keypad reader.
Note: Do not leave the premises.
If the system bypasses a zone, a warning appears on the keypad.
After you initiate the arm sequence, the system completes the following actions:
• The Armed indicator turns on.
• The Ready indicator remains lit.
• The Exit Delay timer begins counting down.
Note: For European installations (EN50131 certified), the Armed indicator turns on only after the
Exit Delay.
PowerSeries Pro HS3032/HS3128/HS3248 User Manual12
To Next Page
Loading...
