- For quick access, press [*] [*], and scroll through the menu to view the temperature
capable zones.
3. To exit, press [#].
Turning the chime on or off
Turning the chime on audibly notifies you when an entry/exit sensor is activated.
To turn the chime on or off, complete the following step:
• Press and hold the Chime key.
Audio verification
Allows the monitoring station to initiate an audio (talk/listen) or 1-way audio (listen-in only)
session when an alarm has been received. This feature is used to verify the nature of the alarm or
determine the type of assistance required by the occupant.
Note: This is a supplementary feature that has not been investigated by UL/ULC.
Note: Must be enabled and configured by installer.
Visual verification
Allows the monitoring station to use video clips captured from system motion cameras for
verification of any alarms.
Note: This is a supplementary feature that has not been investigated by UL/ULC.
Note: Must be enabled and configured by installer.
Video on demand
The video on demand feature uses third-party integrations to obtain video clips on demand from
the connected cameras.
Note: The installer must configure and activate this feature.
PIR camera zone association
The PowerSeries Pro system can link up to eight zones to any passive infrared (PIR) camera that
connects to the system. When a zone goes into alarm, the PIR camera can trigger a video capture
so that a user can verify the alarm.
Note: The installer must configure and activate this feature.
Activating a command output
While being useful for many applications, Command outputs are typically configured to operate
items such as garage doors or electric gates. Additionally, command outputs can be assigned to
follow a schedule configured by your installer.
This is a supplementary feature that has not been investigated by UL/ULC.
Must be configured by installer.
To activate a command output, complete the following steps:
1. On the keypad, press * 7.
35PowerSeries Pro HS3032/HS3128/HS3248 User Manual