Disabling the auto arm time
To disable the auto arm time, complete the following steps:
1. On the keypad, press * 6.
2. Enter your access code.
3. Use the Arrow keys to navigate to Auto Arm Time, and press *.
4. Navigate to the day of the week and press *.
5. Enter 9999.
6. Optional:To disable the auto arm time for another day of the week, repeat Steps 4 to 5.
Configuring the system service DLS
Occasionally, your installer may need to remotely access the Installer programming of your security
system using Downloading Software (DLS). In order for this to successfully occur, you may need to
manually allow access to your system.
Note: The installer must configure the access to this feature.
To configure the system service DLS, complete the following steps:
1. On the keypad, press * 6.
2. Enter your access code.
3. Use the Arrow keys to navigate to System Serv/DLS.
4. Press * to enable or disable the feature.
5. Press # to return to the ready state.
User Callup
Using DLS, User Call-up allows your system to make one attempt to connect to the installer’s
remote computer. For a successful connection, the remote computer must be waiting for the
system’s call.
Note: The installer must configure the access to this feature.
To perform a user callup, complete the following steps:
1. On the keypad, press * 6.
2. Enter your access code.
3. Use the Arrow keys to navigate to User Callup, and press *. The system attempts to connect
to the installer's computer.
4. Press # to return to the ready state.
Configuring the late to open feature
The late to open feature provides notification if the alarm system is not disarmed by the
programmed time of day.
Note: The installer must configure the access to this feature.
To configure the late to open feature, complete the following steps:
1. On the keypad, press * 6.
29PowerSeries Pro HS3032/HS3128/HS3248 User Manual
To Next Page
Loading...
