5. Press # .
Setting the buzzer volume
To set the buzzer volume, complete the following steps:
1. On the keypad, press * 6.
2. Enter your access code.
3. Use the Arrow keys to navigate to Buzzer Control, and press *.
4. Navigate to the volume level that you want.
5. Press #.
Setting the voice prompt volume
This feature is available only when using an HS2LCDWFVPRO wireless keypad.
To set the voice prompt volume, complete the following steps:
1. On the keypad, press * 6.
2. Enter your access code.
3. Use the Arrow keys to navigate to Voice Prompt, and press *.
4. Navigate to the volume level that you want, and press *.
5. Press # to return to the ready state.
Setting the voice chime volume
This feature is available only when using a HS2LCDWFVPRO wireless keypad.
To set the voice chime volume, complete the following steps:
1. On the keypad, press * 6.
2. Enter your access code.
3. Use the Arrow keys to navigate to Voice Chime, and press *.
4. Navigate to the volume level that you want, and press *.
5. Press # to return to the ready state.
Resetting the system
Engineer's reset
If an alarm occurs on your system and the Ready light is off, you cannot rearm your system until
you restore the alarm condition or you bypass the opened zone. When you disarm the system after
an alarm condition, if Reset Required displays on your keypad, contact your installer.
Note: The installer must configure this feature.
Remote (Anti-code) Reset
When configured by the installer, an alarm condition will cause the system to require a remote
reset and arming will no longer be possible after the system is disarmed. This feature ensures that
the end user contacts the monitoring station following an alarm condition. The system keypads
will display that a remote reset is required and will show a random 5-digit remote reset code. You
31PowerSeries Pro HS3032/HS3128/HS3248 User Manual
To Next Page
Loading...
