- Use the [<] [>] keys to scroll to Bypass Options and press [*], and scroll to Program
Bypass Group and press [*].
5. To exit Bypassing mode, press [#].
Loading a bypass group
To load a Bypass group, complete the following steps:
1. On the keypad, press [*] [1].
2. Optional: If it is necessary, enter an access code or present a proximity tag.
3. Choose one of the following options:
- Press [9] [9] [1], and if it is necessary, enter an access code or present a proximity tag.
- Use the [<] [>] keys to scroll to Bypass Options and press [*], and scroll to Bypass Group
and press [*].
4. To exit Bypassing mode, press [#].
Arming troubles and exit faults
Arming troubles
An error tone (long beep) sounds if the system is unable to arm. Arming trouble may occur in the
following circumstances:
• The system is not ready to Arm (i.e., sensors are open).
• An incorrect user code is entered.
• A trouble is present and has not been viewed by the user. This operation must be enabled by
the installer.
Correcting an arming error
1. Ensure all sensors are secure. Your keypad will identify any open sensors.
2. When the trouble light is on, enter [*][2] and enter [99] or scroll to the Acknowledge All
Troubles prompt and press [*]. If your system has been programmed to prevent arming when
a trouble is present.
3. Try arming the system again.
4. If troubles persist contact your installer.
Audible exit faults
Note: This option must be enabled by your installer.
In an attempt to reduce false alarms, the Audible Exit Fault notifies you of an improper exit when
arming the system. Improper exits are caused by failing to securely close the Exit/Entry door.
Improper exits cause the following system notifications:
• The keypad emits one continuous beep.
• The bell or siren sounds for the duration of the entry delay until a valid user code is entered or
until the programmed Bell Time Out expires.
PowerSeries Pro HS3032/HS3128/HS3248 User Manual18
To Next Page
Loading...
