Alarm Cancel window
The control panel provides a period of time in which the user can cancel the alarm transmission
(minimum duration is 5 minutes). If the programmed alarm transmission delay has expired,
canceling an alarm sends a message to the monitoring station. Upon a successful transmission
of the cancellation message, the keypad beeps 6 times. Must be enabled and configured by the
installer.
Note: For CP-01 systems, alarm transmission delay must not exceed 45 seconds.
Viewing alarms in memory
When an alarm occurs the keypad indicator illuminates. Viewing the Alarm Memory provides more
information on the sensor(s) that were activated.
To View Alarms in Memory
Press [*][3] or use the scroll keys to navigate to Alarm Memory and press [*].
Alarm messages
LCD What it means
Burglary Verified Multiple burglary sensors were activated. Central station has
been notified.
Burglary Not Verified A single burglary sensor was activated. Central station has
been notified.
Hold-up Verified Multiple hold-up sensors were activated. Central station has
been notified.
Hold-up Not Verified A single hold-up sensor was activated.
Fire Alarm Fire alarm has been triggered. Central station has been
notified.
CO Alarm CO alarm has been triggered. Central station has been
notified.
Wireless keys
In addition to the keypad, the PowerSeries Pro system can be controlled using a variety of devices:
• Wireless Keys
• Proximity Tags
Using wireless keys
Wireless keys allow users in close proximity of their premises the ability to readily arm and disarm
their system, and to call for help. When using compatible wireless keys there is one beep for
arming and two beeps for disarming. The wireless key buttons can also be programmed for various
functions, including Instant Stay Arm. Check with your installer for details.
Note: The panic feature has not been evaluated by UL for the PG9929/PG9939.
For additional information, refer to your Wireless Key Instruction Sheet.
Using Proximity Tags
Proximity tags can be used to arm and disarm the system, perform a programmed function and
can also be used in place of your user access code.
To operate, present the tag close to the Tag Reader icon on your keypad. The LED bar flashes 3
times upon a valid proximity tag being read by the keypad successfully.
PowerSeries Pro HS3032/HS3128/HS3248 User Manual22
To Next Page
Loading...
