Johnson Controls Tyco PowerSeries Pro HS3032 - Canceling the Arming Sequence; Silent Exit Delay; Arming the System with a Wireless Key; Arming the System with a Proximity Tag

When the Exit Delay timer expires, the system is Armed and the following actions occur:
• The Ready indicator remains lit.
• The Armed indicator remains on.
• The keypad stops sounding.
Canceling the arming sequence
To cancel the arming sequence, complete the following step:
• Enter your access code, or present a proximity tag to the keypad reader.
Silent exit delay
If you arm the system using the Stay key or the No-Entry Arming method [*] [9]:
• The warning beep is silenced
• The exit time doubles only for that exit period (CP-01 versions only).
Note: For non CP-01 versions, Standard Exit Time is used.
Arming the system with a wireless key
If configured, the PowerSeries Pro system can be armed using the wireless keys provided with your
alarm system. To arm the system with a wireless key, press the desired arming mode button when
the system Ready indicator is on.
Arming the system with a proximity tag
Proximity tags can be used to arm and disarm the system or to perform a programmed function
(e.g. used in place of entering an access code or to unlock a storage room door).
To arm the system with a proximity tag
• Present your proximity tag to a keypad with a proximity sensor when the system Ready
indicator is on.
• If configured by your installer, enter your access code.
Note: When arming with a proximity tag, the system arms in Away mode if you exit the
premises. The system arms in Stay mode if a motion sensor is installed and you don't exit the
premises.
Night arming
Night mode partially activates the alarm system by:
• Bypassing all internal sensors configured as Night zones.
• Arming all perimeter sensors.
• Arming all other internal sensors.
Arming the system in Night mode is possible after the system has first been armed in Stay mode
and [*][1] is pressed at the keypad. The keypad can also be configured with a function key to arm
the system in Night Mode. To access armed interior areas when the system is armed in Night Mode,
you must disarm the system.
13PowerSeries Pro HS3032/HS3128/HS3248 User Manual