To loan a keypad to another partition, complete the following steps:
1. Press and hold # for two seconds.
2. Enter your access code.
3. Use the Arrow keys to navigate to a partition, and press *. The keypad is temporarily loaned
to this partition. If the keypad is inactive for more than 30 seconds, it reverts to its original
partition.
The status of each partition will be identified by a partition flag. For an explanation on partition
flags, see the following table.
Table 7: Partition Flags
LCD Display Flag Description
1-8 Partition number
R Partition is ready to be armed
X Partition is in exit delay
A Partition is armed
! Partition is in alarm
E Partition is in entry delay
- Partition is not configured
P Partition auto arm pre-alert
1 2 3 4 5 6 7 8 R X A ! E - P N
N Partition is not ready to be armed
Keypads can also be configured as global keypads, controlling all partitions. Global keypads must
be configured by your installer.
Fire and CO zone types
• If a Fire zone generates an alarm only the partition the fire zone is assigned to will go into
alarm. Other partitions retain their current state.
• If the [F] key on a global keypad is used to generate an alarm all enabled partitions will go into
alarm.
• One or more fire zones may be located on any partition.
• On alarm, the fire auto-scroll display appears on all partition keypads and on all global
keypads. Fire alarm silence and fire system reset may be done directly on any partition keypad.
To silence a fire or CO alarm from a global keypad requires that the global keypad be loaned to
one of the partitions.
Additional Features
Viewing a temperature in a zone
This feature displays the temperature for each active zone. To view the temperature in a zone,
complete the following steps:
Note: An installer must activate this feature.
1. On any partitioned keypad, from the Main menu press [*].
2. Choose one of the following options:
- To select a temperature, press [*].
PowerSeries Pro HS3032/HS3128/HS3248 User Manual34
To Next Page
Loading...
