Trouble conditions
When a trouble condition occurs your Alarm System identifies the problem and displays an error
message. Refer to the table below when you see an error message on the display. If additional help
is required, contact your distributor for service.
When the system detects a trouble condition the following occurs:
• The Trouble indicator turns on.
• The keypad beeps twice every 10 seconds. Press the [*] key to silence the keypad beeps.
Press [*][2] to examine troubles. When viewing troubles, the trouble indicator flashes to identify
the level of trouble being viewed. One flash = level 1, two flashes = level 2 etc. Arming of your
system may be impeded by a trouble. To override this condition, enter [*][2], scroll to Acknowledge
All Troubles and press [*] or enter 999.
Table 8: Trouble conditions
Trouble Condition Trouble Level 1 Description Trouble Types Trouble Level 2 Notification Level 3
Trouble numbers are used to view the trouble. Trouble Notification identifies the range that may be displayed on the
keypad. When exploring the trouble levels, the Trouble indicator will flash to identify which level you are currently viewing.
Bell Circuit 01
RF Jam 02
Loss of clock 04
Output 1 Fault 05
Warm Start 06
USB Wi-Fi
Connected
07
Component fault in
power unit
08
Power Fail Bus
Repeater
09 Repeater 1-16
Power Fail 3A
Supply
10 Power Supply 1-4
Service Required 01 Assorted Trouble
types.
Time and Date
troubles can
be resolved by
resetting the Time/
Date.
To set Time/Date
press [*][6][0][1].
For all other
troubles call for
service.
Overcurrent 11 Call for service
37PowerSeries Pro HS3032/HS3128/HS3248 User Manual
To Next Page
Loading...
