Code type Description
Master code By default, the master code can access all partitions and can perform any keypad
function. This code can be used to program all access codes, including the
supervisor and duress codes. The master code number is [01].
User codes This type of access code is used to arm and disarm assigned partitions and can
access the User Functions menu.
Supervisor codes Use when you want to allow additional users to manage access codes [*5] or
User Functions [*6]. Supervisor codes created by the master code have the same
attributes as the master code. Supervisor codes created by another supervisor
code have the same attributes, except the supervisor attribute. After creation,
attributes can be changed for all supervisor codes. For information on how to
program a supervisor code see "Configuring additional User Options".
Duress codes A Duress Code is used if forced to access your keypad under threat. Duress
codes function the same as user access codes, except they transmit a Duress
Report to your monitoring station when used to perform any function on the
system.
Duress codes cannot be used to change Access Codes [*5], User Functions [*6]
or Installer [*8] programming. For information on how to program a Duress
Code, see "Configuring additional User Options".
One Time user code Used to grant someone one-time access to your home, i.e., a cleaning person or
contractor. The ability to disarm the system is reset at midnight or when the one-
time user code is keyed in by the master code user. For information on how to
program a One Time User Code, see "Configuring Additional User Options".
Opening the access codes menu
To open the Access Codes menu, complete the following steps:
1. On the keypad, press * 5 .
2. Enter your access code.
3. Choose one of the following options:
- Enter the user's number, and press *.
- Use the Arrow keys to navigate through the list of users, and press * to select a user.
4. Press # to return to the ready state.
Adding, changing, and deleting access codes
Each configured user is assigned a number as follows:
• 01-72 for HS3032
• 01-1000 for HS3128
• 01-1000 for HS3248
A “-” beside a user ID indicates it is not programmed.
Adding or changing a user access code
To add or change a user access code, complete the following steps:
1. On the keypad, press * 5.
2. Enter your access code.
PowerSeries Pro HS3032/HS3128/HS3248 User Manual24
To Next Page
Loading...
