Note: Ensure that your installer has provided you with a list identifying all programmed night
zones. Your installer can configure a function key to arm the panel in Night mode without the
system already being armed in Stay mode.
Arming the system in Night mode
To arm the system in Night mode, complete the following steps:
If the system is configured, press and hold the Night Arm key for 2 seconds.
1. After you arm the system in Stay mode, press [*] [*] on any keypad, or press [*] [1].
If it is necessary, enter an access code or present a proximity tag to the keypad reader.
Note: The system arms all interior zones, except for devices that you program as Night Zones.
Disarming a system that is in Night mode
To disarm a system that is in Night mode, complete the following step:
• Enter your access code.
To gain access to interior areas that are armed during Night mode disarm the system by entering
your access code.
No-entry arming
The No-entry feature arms the system in Stay mode and completes the following actions:
• Removes the Entry Delay from configured zones.
• arms all perimeter sensors.
• Bypasses all interior sensors.
Note: When you use the No-entry feature, an attempt to enter through a door or window
creates an instant alarm.
Arming the system using the No-entry arm feature
To arm the system using the No-entry arm feature, complete the following steps:
1. Ensure that the Ready indicator is on, and that the system is ready for Arming .
2. Press [*] [9]. If it is necessary, enter an access code, or present a proximity tag to the keypad
reader.
If the system bypasses a zone, a warning message appears on the keypad.
After you initiate the arm sequence, the system completes the following actions:
• The system flashes and has no entry delay.
• The keypad sounds with a fast beep.
• The system displays Exit Delay in Progress on the keypad.
When the Exit Delay timer expires, the system is armed.
Canceling the arm sequence
To cancel the arm sequence, complete the following step:
• Enter your access code, or present a proximity tag to the keypad reader.
PowerSeries Pro HS3032/HS3128/HS3248 User Manual14
To Next Page
Loading...
