Correcting an exit fault
1. Re-enter the premises.
2. Disarm the system before the entry delay timer expires by entering your access code, or using
a proximity tag, or wireless key.
3. Follow the Away arming procedure again, making sure to close the entry/exit door properly.
For more details see: “Away arming the System with the Keypad”.
Disarming the system
Depending on your system configuration, there are multiple methods you can use to disarm your
system. You can disarm the system using a keypad, a wireless key, or a proximity tag:
Disarming the system with a keypad
Note: When you enter the premises, the keypad sounds. To avoid an alarm condition, you must
disarm the system within a specific number of seconds.
To disarm the system with a keypad, complete the following step:
• Enter your access code, or present a proximity tag to the keypad reader.
Disarming the system with a wireless key
Note: When you enter the premises, the keypad sounds. To avoid an alarm condition, you must
disarm the system within a specific number of seconds.
To disarm the system with a wireless key, complete the following step:
• When the system is armed, and the Armed indicator is on, press the disarm key.
Note: After you disarm a system with a keypad using a wireless key, ensure that you check the
alarm memory to determine if any alarms occurred during the armed period.
Disarming the system with a proximity tag
Note: When you enter the premises, the keypad sounds and indicates entry delay. To avoid an
alarm condition, you must disarm the system within a specific number of seconds.
To disarm the system with a proximity tag, complete the following step:
• When the system is armed, and the Armed indicator is on, present a proximity tag to the
proximity sensor on the keypad.
Note: The installer programs the Duration of Entry timer, and advises on the duration of the
timer. Valid entries are between 30 seconds and 4 minutes. For SIA CP-01 classified installations,
the entry delay must not exceed 45 seconds.
Disarming error
If your code is invalid, the system does not disarm and a 2-second error tone sounds. If this occurs,
press [#] and re-enter your access code.
Alarms
The system can generate different alarm sounds, each with a different purpose and priority.
19PowerSeries Pro HS3032/HS3128/HS3248 User Manual
To Next Page
Loading...
