DP350 User's Manual
- 21 -
In offline mode, press the SPEED key to switch the print mode among Normal Speed mode, High Speed
mode and Super High Speed mode. The green LED denotes normal speed mode, the yellow one
denotes the high speed mode and the red one denotes the super high speed mode.
2.4.4 Copy Setup Mode
Printer will turn on the Copy mode automatically when the gap adjust lever is set to 3 (or higher).
In order to improve the copy definition when using multi-ply paper, you can select the copy capability
through the following steps:
1. In Online mode, long press SPEED key + TEAR key for about 3 seconds, after the printer beeps three
times, the PAPER OUT LED and ONLINE LED blink at the same time, and the printer would present
one beep every one or two seconds which indicates the printer has entered into Copy setup mode.
2. The SPEED LED indicates the current Copy setup mode:
Green denotes the quiet mode, orange denotes the normal mode and Red denotes the copy mode.
3. In Copy setup mode, press LF/FF key can switch the printer among quiet mode, normal mode and
copy mode.
4. After setting the Copy setup mode. Long press SPEED key + TEAR key for about 3 seconds, the
printer presents 3, which indicates the printer has saved the setting and exited the Copy setup mode.
5. You could also set Copy setup mode through driver or menu setup mode. (See details in User’s
Manual)
2.4.5 Micro-Adjust of the Printing Home Position and the Tear Position
Operation steps of adjusting the printing home position: (the printing home position of cut sheet is
separated with that of the tractor paper. The following is use tractor paper for example)
1. Turn on the printer. Pull the paper-select lever to tractor paper mode, press LOAD/EJECT key to
load tractor paper.
2. Press ONLINE key to ensure the ONLINE LED blinks. Hold on pressing ONLINE key for about 3
seconds till the printer beeps once. The ONLINE LED and PAPER OUT LED blinks alternately.
Note: Don’t press SPEED key now, or the printer can’t enter the micro-adjust mode.
3. Press LF/FF and LOAD/EJECT keys to adjust the printing home position.
4. Press the ONLINE key again to save and quit the alternate mode after finishing adjusment.
The operation step of adjusting the tear position is basically the same with that of the printing home
position. But the exclusive difference is pressing TEAR to feed paper to the tear position after installing
the tractor paper.
Note: Don’t revolve the paper feed knob when the printer is in the process of the micro-adjust.
Remark: The adjustable range of printing home position is from -18/60 inch to +60/60 inch
(base on default position set by the factory).
The adjustable range of tear position is from -15/60 inch to +15/60 inch (base on
default position set by the factory).
2.4.6 Feed Paper to the Tear Position
1. Turn on the printer, hold the ONLINE key 3 seconds when offline till the ONLINE LED blinks with a
beep.
2. Hold the TEAR key 3 seconds that you can switch the function of feeding paper to the tear position
automatically ON or OFF.
To Next Page
Loading...
