DP350 User's Manual
- 28 -
3.2 Changing the Printer Settings
3.2.1 Setting Printer Parameter Through the Control Panel
1. Press the ONLINE key on the control panel while turning on the printer. The print head returns with
the printer beeping once. If the ONLINE LED and the PAPER OUT LED blink at the same time, it
indicates that there is paper out.
2. Set the paper-select lever to the proper position. (If in cut sheet mode, the paper select lever should
in the cut sheet position, otherwise, it should in the tractor paper position.)
3. After loading paper, in cut sheet mode, the printer would print out the current setting automatically. In
tractor mode, after install the paper to the tractor, once you press LOAD/EJECT key, the printer
would load paper to printing home position and start to print the current setting.
To Next Page
Loading...
