Jolimark DP350 - 3.4 Restore the Default Settings

DP350 User's Manual
- 36 -
with an alarm.
BLACK MARK
After select this function on, printer would carry out black mark detect instruction
so that to make the vertical positioning printing precisely. (Bills or papers should
have black mark on the surface.)
PIN SWITCH
After select this function on, printer would switch different pins to print table line
automatically.
BAUD RATE Specify the printer serial data transfer rate.
PARITY Specify the parity bit for serial data transfer.
DATA BIT Specify the serial data bits.
STOP BIT Specify the serial data transfer stop bit.
PROTOCOL
Specify the protocol of printer serial data transfer as software control
(XON/XOFF) or hardware control (DTR).
PIN TEST
Select the broken pin. Printer would automatically replace it with other pin to
print.
3.4 Restore the Default Settings
1. Hold on TEAR, LOAD/EJECT and LF/FF keys on the control panel at the same time while turning on
the printer. The LEDs of the PAPER OUT and ONLINE on the control panel blink 3 times respectively at
the same time and the printer makes two beeps to confirm that the printer’s factory settings have been
restored.
2. Loosen the keys and switch the printer off and on again.
3. After these steps, the printer’s factory settings work.
Note: After restoring all the factory default settings, network setting parameters resume default
value at the same time.