DP350 User's Manual
- 22 -
2.4.7 Other Functions of the Control Panel
KEY FUNCTION
ONLINE + POWER
Print current setting mode; If long press the LOAD/EJECT+ LF/FF
keys down in online mode, the printer would enter into menu setup
mode.
POWER + LOAD/EJECT Chinese self-test mode
TEAR + POWER ASCII self-test mode
TEAR + LF/FF + POWER Hex dump mode
LF/FF + POWER Print pin test, which to test whether the print pins are in good condition.
2.5 Paper Select Lever
Set paper-select lever toward the cut sheet or tractor paper position to select cut sheet mode or tractor
paper mode.
2.6 Paper Feed Knob
The paper feed knob is used to feed paper or eject paper manually. In general, it’s better not to use it.
2.7 The Gap Adjust Lever
The gap adjust lever lets you specify the correct setting for your printing material. It is factory-set for
standard office paper.
POSITION PAPER TYPE
-1 reserved
0 Cut sheet
1 2 plies
2 3 plies
3 4 plies
Fanfold
paper
4 reserved
5 reserved
Figure 2-2 Paper-select lever
Figure 2-3 the gap adjust lever
To Next Page
Loading...
