Jolimark DP350 - 4.4 Alignment Adjust Mode

DP350 User's Manual
- 40 -
printer, then press the LF/FF key to feed the paper forward. When using the tractors, tear off the
last printed paper, then press the LOAD/EJECT key to feed the paper backward.
2. Please make sure the paper length is within specified range. (Refer to the paper specifications in
Appendix A)
Phenomenon 4: When you switch between cut sheets and tractor paper, the beeper sounds
some times and the ONLINE LED is off.
Solutions: There is paper left in the paper in channel while you are changing the paper-select lever
position. Return the paper-select lever to the previous position and eject the paper. Then
change the paper-select lever position again.
4.4 Alignment Adjust Mode
Enter the alignment adjust mode to improve the print quality when the printer is used for a long time.
Note: 1. When the gap adjust lever is in the position of 3 or above, the printer is in copy mode
automatically. Users can set the gap adjust lever according to specific paper type (cut
sheet or tractor paper), then adjust the alignment following the steps below.
2. You must use the 80 columns tractor paper when adjusting alignment.
Alignment adjustment includes normal print mode adjustment and copy mode adjustment.
Alignment test and adjusting procedure of normal mode adjustment:
1. Turn on the printer, and then install 80 columns tractor paper correctly.
2. In the online mode, press and hold on the LOAD/EJECT key and TEAR key until the PAPER OUT
and ONLINE LEDs blink simultaneously, the printer enters the alignment adjust mode and print out
the DPI alignment setting.
3. After entering the alignment adjust mode, press the following keys to adjust the degree of make
columns:
EJECT/LOAD Each press this key, the even line would move left with one step (the adjusted
value is increased)
Press ONLINE key to check the result.
LF/FF Each press this key, the even line would move right with one step (the adjusted
value is decrease)
Press ONLINE key to check the result.
TEAR Switch to the next DPI adjust state
ONLINE Store and print the current settings
4. Restart the printer and exit the alignment adjust mode.
Alignment test and adjusting procedure of copy mode adjustment:
1. Turn on the printer, and then install 80 columns tractor paper correctly.
2. In the online mode, press and hold on the LF/FF key and TEAR key until the PAPER OUT and
ONLINE LEDs blink simultaneously, the printer enters the alignment adjust mode and print out the
DPI alignment setting.
3. After entering the alignment adjust mode, press the following keys to adjust the degree of make
columns:
EJECT/LOAD Each press this key, the even line would move left with one step (the adjusted
value is increased)
Press ONLINE key to check the result.
LF/FF Each press this key, the even line would move right with one step (the adjusted
value is decrease)
Press ONLINE key to check the result.