2. Installation
JCX-161 BNWAS Installation Manual
22
7ZPNA4321
2.3.3 Flush mounting installation
Install in the following procedure.
Do not tighten a screw too much. Doing so may result in damage of installation holes.
(1) Insert the main unit in the installation location.
(2) Fix the main unit using screws (provided by the shipyard).
The sizes of the heads of the screws that are used are restricted as follows including the
washers.
• Diameter: Up to φ8 mm
• Height: Up to 4.5 mm
(3) Insert the front panel into the main unit
To Next Page
Loading...
