4. Installation setting
JCX-161 BNWAS Installation Manual
87
7ZPNA4321
4.4 Setting RMS OUTPUT
This function is to set output ON/OFF of RMS messages to VDR.
Operating procedure
1) Display the maintenance menu by referring “4.1 Changing to maintenance mode”.
2) Select “RMS OUTPUT” with , and then press . After that, the following screen is
displayed.
3) Select a setting channel with , and then press in order to become the ON/OFF setting
condition.
4) Select ON/OFF with , and then press . After that, its channel is set.
5) Press in order to return to maintenance mode.
BNWAS RMS OUTPUT
RMS OUTPUT: OFF
▼
■
[M]
To Next Page
Loading...
