JRC JCX-161 - Password Reset Function; MASTER RESET Function

4. Installation setting
JCX-161 BNWAS Installation Manual
93
7ZPNA4321
4.5.5 Password reset function
This function is to reset a user password to the initial value “0000”.
Operating procedure
1) Display the maintenance menu by referring “4.1 Changing to maintenance mode”.
2) Select sequentially “MAINTENANCE” and “PASSWORD RESET” with .
3) Since the following pop-up is displayed, in performing, select "YES", and in canceling, select
"NO."
Then, 󲨘󲨘 is pressed.
4.6 MASTER RESET function
When master reset is performed, the setting values are reset to the default values shown in the
following page.
Before performing master reset, it is recommended to keep a record of the current setting values.
Operating procedure
1) Display the maintenance menu by referring “4.1 Changing to maintenance mode”.
2) Select “MASTER REST” with , and then press .
3) Since the following pop-up is displayed, in performing, select "YES", and in canceling, select
"NO."
Then, 󲨘󲨘 is pressed.
INITIALIZE
YES NO
RESET A PASSWORD?
YES NO