JRC JCX-161 - Removing the LCD Display Unit for Flash Mounting Installation

2. Installation
JCX-161 BNWAS Installation Manual
23
7ZPNA4321
2.3.4 Removing the LCD Display unit for flash mounting installation
Remove the LCD Display unit in the following procedure.
(1) Insert a hexagonal wrench into a one of the 2 holes at the bottom of the front panel.
(2) Remove the front panel by pressing down the hexagonal wrench.
Mounting wall
Front panel
Prepare a board to protect
the wall from being damaged.
Hexagonal wrench
(provided by the shipyard)
Recommended size: 3 mm
Press down