4. Installation setting
JCX-161 BNWAS Installation Manual
83
7ZPNA4321
4.1 Changing to maintenance mode
Before starting this installation setting, the mode must be changed to a maintenance mode to
prevent an operation error.
Change the mode to a maintenance mode by the initial operation.
Operating procedure
1) Display a main menu by pressing
(normal mode).
2) Press long
and for 3 seconds.
3) The menu is changed to a maintenance menu (maintenance mode).
When the mode is changed to a maintenance mode, the [M] icon is displayed at the bottom of
the screen.
Normal mode
Maintenance mode
• Returning to a normal mode
When is pressed or no operation is performed for 10 minutes, the mode is reset to a normal
mode.
When the power is turned on, the system starts in normal mode.
BNWAS MENU
SET VALUE
OFFICER CALL
ALARM
HISTORY
DISPLAY
BUZZER TEST
■
The [M] icon is
displayed.
Press and for 3 seconds
BNWAS EQUIPMENT
BUZZER CH
NMEA COMM
RMS OUTPUT
MAINTENANCE
MASTER RESET
SOFT UPDATE
■
[M]
To Next Page
Loading...
