3. Wiring
JCX-161 BNWAS Installation Manual
47
7ZPNA4321
• Wiring method
The cable outer diameter corresponds to AWG 28 ~ 12.
1) Cable preparation work
Strip off insulation by 8 to 9 mm.
2) Wiring to terminal block
Prepare a flat head screwdriver in which the spring of a terminal block carries out full
opening at 3.5 mm or less in width.
Insert the screwdriver into a square opening on upper portion of the terminal block as far
as it goes, and then insert the cable. After that, pull out the screwdriver.
3) Fixing of cable
8-9mm
3.5mm
Fix cables on the clamp by
a cable tie.
To Next Page
Loading...
