Attention in use
JCX-161 BNWAS Installation Manual
v
7ZPNA4321
When the system is exposed to fresh water or seawater, wipe it immediately.
Otherwise, a failure or malfunction may occur.
When cleaning the system surface, do not use any organic solvent such as
thinner or benzine; these solvents damage the surface coating.
To clean the surface, remove dust and debris and then wipe it with a clean dry
cloth.
Connect the ground wire to a grounded terminal. Otherwise, an electric shock
may occur as the result of a failure or earth leakage.
Avoid sharing a power source with a system (such as an air conditioner) that
generates a large amount of electronic noise. The system may not function
properly because of short - time voltage drop or noise carried from power
source.
Do not place the system on an unstable place such as a wobbly rack or incline.
The system may drop or fall, resulting in personal injuries and/or equipment
failure.
Do not place the system in a place exposed to direct sunlight. Otherwise it may
cause damage on the paint or seal on the surface.
Do not install the equipment near any radio equipment. Otherwise it may cause
a signal reception affected.
CAUTION
To Next Page
Loading...
