3. Wiring
JCX-161 BNWAS Installation Manual
78
7ZPNA4321
2) Cable preparation work
Strip off insulation by 5 to 6 mm.
3) Wiring to terminal block
Prepare a flat head screwdriver in which the spring of a terminal block carries out full
opening at 3.5 mm or less in width.
Insert the screwdriver into a square opening on upper portion of the terminal block as far
as it goes, and then insert the cable. After that, pull out the screwdriver.
4) Fixing of couching clip
After the cables are connected to the terminal block, coil tightly the couching clip in the
housing to the cables.
Coaching clip
5-6mm
3.5mm
To Next Page
Loading...
