7.5 MAINTENANCE MENU
ņ60
7
yyy
yyyy
[IV] Display Unit -> Antenna (Display Unit to TXRX)
Restore the antenna time data from the display unit into the antenna's internal control circuit.
Perform the following procedure to inherit the antenna time data when the antenna's internal control circuit is
replaced.
1. Saving the antenna time data
2. Replacing the antenna's internal control circuit
3. Restoring the antenna time data
Note: This function can be performed only when the scanner is connected to NKE-2043, NKE-2063A,
NKE-2103, and NKE-2254.
Procedure 1 Hold down [RADAR MENU] key.
The Code Input Menu will appear.
2 Press [0] key.
3 Move the cursor onto the “ENT” button
in the Code Input menu, and press
[ENT] key.
The Adjust Menu will appear.
4 Press [2] key.
The Maintenance Menu will appear.
5 Press [6] key.
Press [4] key.
6. Select Yes in the Display Unit -> Antenna Confirmation Window.
The antenna time data in the display unit is restored transferred to the antenna's internal
control circuit.
To Next Page
Loading...
Need help?
General
