JRC JMR-7210-6X - Page 538

Section 16 Setting up Screen View 16-16
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Show ETA Selecting this enables to display the ETA
(estimated time of arrival at WPT) while
route monitoring.
To enable: Select.
To disable: Clear.
Format When ETA is enabled, select a display
format of the ETA while route monitoring
by clicking on the corresponding button.
: UTC
: LMT
UTC/LMT
XTD Limit Line Selecting this enables to display XTD limit
lines.
To enable: Select.
To disable: Clear.
Color
When XTD Limit Line is enabled, select a
display color of XTD limit lines by clicking
on the corresponding button.
IALA-A: Starboard - green, Port - red
IALA-B: Starboard - red, Port - green
IALA-A, IALA-B
Show WPT Name
(Comment display)
Selecting this enables to display a
comment on the vicinity of the target.
To enable: Select.
To disable: Clear.
WPT Name Font Size
(Comment font size)
When Show WPT Name is enabled, select
a font size of comments by clicking on the
corresponding button (preview not
supported).
Standard, Small