JRC JMR-7210-6X - Page 545

16-23 Section 16 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
AIS Symbol Selecting this enables to display the AIS
symbol.
To enable: Select.
To disable: Clear.
Sleeping Class A, Class
B
Selecting this enables to display the
sleeping AIS of class A, ClassB.
To enable: Select.
To disable: Clear.
Physical AtoN Selecting this enables to display the
Physical AIS AtoN when the AIS Symbol is
selected.
To enable: Select.
To disable: Clear.
Virtual AtoN Selecting this enables to display the Virtual
AIS AtoN when the AIS Symbol is selected.
To enable: Select.
To disable: Clear.
TT Symbol
Select this item to enable the TT symbol.
Select the TT Symbol to be used from the
combo box.
TT1 Symbol
TT2 Symbol
TT1 Symbol indicates the TT target
information that is received from RADAR1
and the TT Target ID is displayed as “T1-***”
(*** indicates the target number or ship
name).
TT2 Symbol indicates the TT target
information that is received from RADAR2
and the TT Target ID is displayed as “T2-***”
(*** indicates the target number or ship
name).
Note
This item is only enabled on the RADAR
screen.
To enable: Select.
To disable: Clear.
TT Vector Selecting this enables to display the TT
vector.
Note
This item takes effect only on the ECDIS
screen.
To enable: Select.
To disable: Clear.
GPS Buoy
Selecting this enables to display the GPS
Buoy symbol.
To enable: Select.
To disable: Clear.