Section 16 Setting up Screen View 16-54
16.2.16 Setting up the display of range/bearing
measurement function
When you select [Tools] in the classification pane, the [Tools] dialog is displayed in the edit pane.
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Range Rings Selecting this enables to display range
rings.
To enable: Select.
To disable: Clear.
Bearing Scale Selecting this enables to display the
bearing scale.
Note
This item is displayed on the ECDIS
screen only. This item is enabled only
when overlay is set to On.
To enable: Select.
To disable: Clear.
EBL1/EBL2 Selecting this enables to display the
EBL1/EBL2 markers.
To enable: Select.
To disable: Clear.
VRM1/VRM2 Selecting this enables to display the
VRM1/VRM2 markers.
To enable: Select.
To disable: Clear.
PI (parallel line cursor) Select this to enable to display the PI
cursors, and then select the PI cursors
you want to display by selecting them.
To enable: Select.
To disable: Clear.
PI cursor selections
Index Line 1 to Index Line 8
Node Fixed EBL/VRM Selecting this enables to display the
node fixed EBL/VRM.
To enable: Select.
To disable: Clear.
To Next Page
Loading...
