JRC JMR-7210-6X - 18.12 Setting Parameter Values at Route Plan Creation

Section 18 Setting up the Operation Mode 18-24
18.12 Setting Parameter Values at Route
Plan Creation
Select [Route] in the classification pane.
Set various parameter values at route plan creation in the setting dialog of the edit pane.
Set up the factory setting values for routes to be created during route planning.
Setting Item Description of Setting Setting Value
Route Mode Set up the route display mode.
Standard:The ordinary ECDIS route will be
used.
NMEA:NMEA destination will be used.
Standard
NMEA
XTD (PORT) Set up the cross track limit of the port side. 0.01 to 9.99 NM
XTD (STBD) Set up the cross track limit of the starboard
side.
0.01 to 9.99 NM
Arrival radius Set up the radius of the WPT (waypoint)
arrival circle.
0.01 to 9.99 NM
Speed Set up the planned speed. 1.0 to 99.9 kn
Sail Set up sailing (RL (Rhumb Line) or GC (Great
Circle)).
RL
GC
Turning Radius Set up the turn radius. 0.10 to 9.99 NM
Time Zone Set up the time zone. -13:30 to +13:30