Section 18 Setting up the Operation Mode 18-40
Receiving only the NAVTEX messages that satisfy a specific condition
Click the Display Filtering for NAVTEX Receiver button to open the "Display Filtering for NAVTEX
Receiver" (NAVTEX Message Receive Filtering) dialog.
In this dialog, you can filter (narrow down) the displayed NAVTEX message.
1 Click the Display Filtering for NAVTEX Receiver button.
A dialog box labeled "Waiting for a response from the NAVTEX receiver" is displayed.
2 When the NAVTEX receiver is connected, open the "Display Filtering for NAVTEX Receiver"
dialog (NAVTEX Message Receive Filtering) dialog.
If there is no response from the NAVTEX receiver, a popup with "No response from NAVTEX
receiver" is displayed. When this popup is displayed, check the connection with the NAVTEX
receiver.
Setting item Setting contents Setting value
FREQUENCY Displaing NAVTEX frequency. RX(518 KHz)
Setting Type Select the setting type of the
NAVTEX receiver.
RX Station / Message Type
Setting
Printer Message Output
Setting
INS Message Output Setting
Station – Display
Filtering
Choose from which base station to
receive and output messages.
If you check the Display Filtering
check box, you can check the check
box of each base station.
Next, check the check box of the
desired base station and select it.
Enable: Check
Disable: Uncheck
To Next Page
Loading...
