JRC JMR-7210-6X - Page 93

6-39 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
List of target tracking simulator/scenario
Scenario Target No.
Motion
(true motion)
Moving start point
Speed [kn] Course [
o
] Range [NM] Bearing [
o
]
Scenario1 1 28.3 45 9.5 270
2 22.4 27 1.12 333
3 15.3 293 9.25 45
Scenario2 1 30 135 8 23
2 20 270 5 135
Scenario3 1 45 180 5 23
2 0 - 3 340
3 30 0 8 180
Scenario4 1 0 0 2.02 31
2 70 225 7.01 37
Scenario5 1 20 45 4.47 288
2 30 45 5.1 304
3 40 45 6.71 288
4 0 - 7.07 307
5 60 200 12 352
6 20 225 11 315
7 40 190 14.4 349
8 - - 8 318
9 - - 9 318
10 - - 10 318
Scenario6 1 5 96 5 0
2 105 225 6 45
Note
• When the simulator is operating, set 0 as the heading bearing
5 Click on the Standby/Transmit selector button to place the radar in the transmission
state.
The button indication changes to [Transmit].
The simulator turns on, the pseudo-target is generated, and the letter "X" appears on the lower
side of the radar screen and near the pseudo-target to indicate that simulation mode is being
executed.
To cancel simulation
1 Click on the Standby/Transmit selector button to place the radar in the standby state.
The button indication changes to [Standby] to enter transmission preparation state.
2 Select [Off] from the [TT Simulator] combo box in the [TT Test] dialog.
TT Simulator display turns off.