107
❾
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
1. Attach the buttonhole presser foot
to the presser foot holder, with the
clamping plate
together.
2. Place the fabric between the presser
foot and the clamping plate.
* You can remove the clamping plate by holding
B
.
●
Buttonhole clamping plate
❽
6
Unplug the sensor pin
❹
after sewing.
7
Opening the buttonhole using a ripper
❼
.
[Double bartack]
Pierce a stopper pin
❽
at the bartack and open the
buttonhole with a ripper
❼
. Be careful not to cut the
stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch
❾
. Then pierce a stopper
pin at the bartack and open the buttonhole with a rip-
per.
❼
B
❹
Leave the machine in Lock mode
To Next Page
Loading...
