(6) How to operate the restart switch
The
restart
switch
Is
typically
used
to
restart
sewing a
step
after
an
empty
bobbin
has
been
replaced.
@19
UUUU
•JUKI
+ +
r+
+
The bobbin thread has run out while
sewing
a step. O
Set the pedal to the neutral position to stop sewing, and
depress the back part of the pedal to trim the threads.
o
Press
restart
switch
o . o
Replace the empty bobbin, route the bobbin thread, and
move
the
material
back
a little to overlap the sewn
stitches in step 2. O
Depress
the front part of the
pedal.
Hold the pedal
depresseduntil stop point Q of step 2 is reached.
6)
At
stop
point
Q ,
press
restart
switch
O .
This
causes the next step to be displayed as I
131
, and
the programmed stitching pattern will go on.
* If a thread breaks during the free sewing operation
initiated by restart switch O ( ®
©),
set the
pedal back to its neutral position, and then depress
the back part of the pedal to actuate the thread trimmer.
Re-thread the machine, and move the material back a
little
before
pressing
restart
switch
O . By so
doing,
you can resume the free sewing operation. After that,
perform steps 5) and 6).
(Note) Follow the procedure shown below when going back
to
the
first step
without
using restart switch O ^
1) Thebobbin thread hasrun out
while
sewing
step 2. O
2)
Set the pedal back to its neutral position to
stop
sewing,
and depress the back part
of
the pedal to trim the
threads. ©
3)
The
step
display
will
show
I
111
,
enabling
you
to
start from
the
beginning.
-
20
-
To Next Page
Loading...
Need help?
General
