JUMO 703041 - Page 65

65
9 Tuning (optimization)
Start of autotuning during operation
Starting auto-
tuning
h Start with
I and D (simultaneously >2sec
“tUnE” is shown, blinking, in the lower display
Autotuning is ended when the display automatically
changes over to normal display.
The duration of autotuning depends on the control
process.
Canceling auto-
tuning
h Cancel with
I and D (simultaneously)
H
The type of controller outputs has to be defined for autotuning.
v Chapter 8.2 “Controller “Cntr””
For a device configured as program controller, the autotuning can only be
started if no program is running (normal display).
In case of problems, you may find further information at www.jumo.net
(Support/FAQ).
IIIIIIIIIIII
I
I
I
I
I
I
I
I
I
I I I I I I I I I I I I I I
I
I
I
I
I
I
I
I