Juniper ACX7348 - Page 119

2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
3. Disconnect power to the router. If the AC power source outlet has a power switch, set it to the o
(O) posion. If the AC power source outlet does not have a power switch, gently pull out the power
cord plug connected to the power source outlet.
4. Remove the power source cable from the power supply faceplate. Remove the power cord from the
power supply faceplate by gently pulling out the socket end of the power cord connected to the
power supply faceplate.
5. Slide the ejector lever toward the handle unl you can no longer slide it (see Figure 63 on page 111).
Figure 63: Remove an AC PSM from the ACX7348 Router
6. Grasp the PSM handle and pull rmly to slide the PSM halfway out of the chassis.
7. Place one hand under the PSM to support it and slide it completely out of the chassis. Take care not
to touch power supply components, pins, leads, or solder connecons.
8. Place the PSM in the anstac bag or on the anstac mat placed on a at, stable surface.
Install an ACX7348 AC Power Supply Module
Before you install a PSM in a router, ensure that you have taken the necessary precauons to prevent
electrostac discharge (ESD) damage (see Prevenon of Electrostac Discharge Damage).
To install an AC PSM in an ACX7348 router:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
111