Juniper ACX7348 - Connect ACX7348 to External Devices

11. Close the input circuit breaker.
12. Connect the power supply to the power sources.
CAUTION: The connecon between each power source and PSM must include a
circuit breaker. We recommend that you use a customer-site 2-pole circuit breaker
rated for 63 A, 80 VDC, or as required by local electrical code.
Connect ACX7348 to External Devices
SUMMARY
You congure and manage the ACX7348 router
using a dedicated management channel. The Roung
Engine in the ACX7348 router has a console port
that you connect to using an Ethernet cable with an
RJ-45 connector.
IN THIS SECTION
Connect an ACX7348 Router to a
Management Console | 87
Connect an ACX7348 Router to a Network
for Out-of-Band Management | 88
Connect to 1-PPS and 10-MHz Timing
Devices | 89
Connect an ACX7348 Router to a GNSS
Antenna | 90
Connect an ACX7348 Router to a Management Console
Each ACX7348 router has a console port with an RJ-45 connector. Use the console port to connect the
device to a management console or to a console server.
To connect the ACX7348 router to a management console:
1. Connect one end of the Ethernet cable to the console port (labeled CON).
2. Connect the other end of the Ethernet cable into the console server (see Figure 43 on page 88) or
management console (see Figure 44 on page 88).
87